Apache Technologies 14 Návod k obsluze stáhnout pdf (Strana 8)

5 Operation - Primary Switch Functions

1. Power Switch - Press the

power switch to turn power

ON. All LED's, the LCD,

and the beeper will come

on momentarily. CAL will be

displayed and LED's sequenced

as the unit goes through a

self-calibrating procedure for

approximately 3 seconds.

NOTE: Do not power up the unit in a laser beam or strobe.

If detected, the unit will revert to the previous calibration.

Press and hold the Power switch for 2 seconds to turn power OFF.

2. Units of Measure Switch - Press once to display the current

settings in the numeric display area. Press again while the

units are displayed (within one second) to change the current

selection. Subsequent presses will scroll through the setting

selections of centimeters (cm), millimeters (mm), inches (in),

fractional inches (in), and feet (ft). For fractional inches, the

fraction bar will be displayed on the LCD. The selected setting

will always be displayed on the top of the LCD.

3. Volume Switch - Pressing the switch cycles High, Medium,

Low and Off. One beep is emitted at the selected volume when

changed. When sound if Off, a single beep will signal that a laser

beam has been detected.

4. Accuracy Switch - Press once to numerically display current

accuracy settings on the LCD. Press again while the accuracy is

displayed (within one second) to change the current selection.

Subsequent presses will scroll through ve accuracy options

(Ultra Fine, Super Fine, Fine, Medium, Coarse). Refer to §11,

Specifications, for details.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Žádné komentáře

Apache Technologies 14 Návod k obsluze Strana 8