Apache Technologies 14 Návod k obsluze stáhnout pdf (Strana 15)

8 Special Functions

Capture Function: The Capture function is used to obtain

a single reading and keep it displayed. This may be useful

when the unit may not be visible and grade information

needs to be obtained.

When in the laser beam and power on, momentarily press the

Power/Capture switch. The current elevation reading will be saved.

A ashing display will conrm the reading has been captured.

Press any switch to return to normal operation.

When out of the laser beam and power on, momentarily press

the Power/Capture switch. A short intermittent beep and 'WAIT'

displayed on the LCD conrm the Capture mode. (The beeper will

turn on to Low if turned off.) Place the receiver in the beam. The

beeper will chirp rapidly after approximately 5 seconds conrming

beam capture. A ashing display will also conrm the reading has

been captured. Press any switch to return to normal operation.

Calibration Mode: Pressing the Power and

Accuracy switches together when the unit is off

enables entry into a laser calibration accuracy mode.

This mode is not marked on the unit.

This accuracy is designed to be used when calibrating a laser.

It is not recommended for eld use. Refer to §11, Specications,

for calibration mode values.

Calibration mode will be conrmed on the LCD by the accuracy

indicators without the on-grade bar.

Press any key or cycle power to exit the calibration mode and

return to the previously stored accuracy setting.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Žádné komentáře

Apache Technologies 14 Návod k obsluze Strana 15